Product Descriptions and Specifications

Mobile Home Roofing Previous page

Drill Point Fasteners

RoofWrap Drill Point Fasteners are manufactured from C-1022 Cold Heading Wire with a low profile #10 truss with a hex head drive.

Basic Uses

RoofWrap Drill Point Fasteners are designed specifically for the mechanical attachment of RoofWrap Prefabricated Vent Hoods and Flashings, Hybrid Roof Attachment Strips and RoofWrap Termination Bar for edge termination and roof profile angle changes. Refer to the RoofWrap Installation Guide for installation instructions.

Technical Services

Contact RoofWrap at (206) 550 7336 for technical service information.

Disclaimer

The statements provided concerning the material shown are intended as a guide for material usage and are believed to be true and accurate. No statement made by anyone may supersede this information, except when done in writing by RoofWrap. Since the manner of use is beyond our control, RoofWrap does not make nor does it authorize anyone to make any warranty of merchantability or fitness for any purpose or any other warranty, guarantee or representation, expressed or implied, concerning this material except that it conforms to RoofWraps physical properties. Buyer and user accept the product under these conditions and assume the risk of any failure, any injury of person or property (including that of the user), loss or liability resulting from the handling, storage or use of the product whether or not it is handled, stored or used in accordance with the directions or specifications. RoofWrap must be notified in writing of any claims and be given the opportunity to inspect the complaint or failure before repairs are made.

Previous Page